Calibration Dynamics
Calibration and Test Equipment
01264 339 030
Email
- News Home
- WIKA have successfully added the DH-Budenberg Group to their portfolio
- Product Range Expansion: WIKA Dead Weight Testers
- ATEX Approved Digital Pressure Gauge - CPG1000
- Wika Calibration Line has introduced a new range of user-defined Calibration Service Kits.
- New WIKA CPH6600 compact handheld pressure indicator
- Scanivalve DSA3307 Wet/Wet Differential Pressure Scanner
- New Avionics Digital Pressure Gauge - CPA2501
- New Temperature Calibrators
- CPC 3000 High Speed Pressure Controller
- 2500 Digital Pressure Gauge
- Series B20
Scanivalve DSA3307 Wet/Wet Differential Pressure Scanner APR 2010
Scanivalve Corporation has launched a new Digital Sensor Array designed for use in Turbine & Diesel Engine Testing or Liquid Measurement Applications. This innovative instrument enables different fluids to be measured on a single instrument.
Click Here for DSA3307 Datasheet
For Further Information Please Contact Us
The DSA3307 incorporates 2 to 16 temperature compensated media isolated piezoresistive pressure sensors. Each DSA module also contains RAM, a 16 bit A/D converter, and a microprocessor using VX Works real time operating system, in a compact self-contained module. The result is a network ready intelligent pressure scanning module for “all media” service.
The microprocessor compensates for environmental temperature changes and performs engineering unit conversion. Pressure data are output in engineering units via Ethernet using TCP/IP protocol.
Features:
- Ethernet TCP/IP ‘Network Ready'
- 0 to 1500psi Pressure Range
- Temperature Compensated Sensors
- Liquid Pressure Measurement (psid, psig, psia)
- ‘All Media' Compatibility
- Time Stamped Data Available
- 500 Samples/Channel/Second
Configurations:
Gauge & Absolute - Wet/Dry
This model contains a stainless steel diaphragm isolating the measurement side of each pressure transducer from the media. The back side of the gauge transducer must be dry. This design also contains a bleed valve per transducer for venting gas bubbles from the input lines. These individual bleed valves also allow for back filling the DSA input lines.
Differential - Wet/Wet
This NEW model contains 2-16 single sensing element pressure transducers that are isolated from the media on both sides by a 316L stainless steel diaphragm. It is used in applications for measuring flow or when measuring high line low differential liquid measurements.